Top left picture shows the high-pressure cell (Mcell 10) attached on the SQUID sample probe, and the top right picture shows the "Mpress" and pressure reader.
I have to say that, when cooling down the pressure cell in the SQUID, the cell keeps loosing from the top screw, and eventually falls off from the probe, even I use Mpress to tight it up to 50 N. Hence, the sample longitudinal scan is changing with time. Maybe I haven't find the trick to avoid it.
1 comment:
Hello Yu,
I have just noticed this blog post of yours. Here is a trick you can use. Just wrap some Teflon tape to the top screw. When you do that, you should find that it doesn’t fall off anymore.
If you are still having problems, please feel free to contact me.
Many thanks and best wishes,
Marcio.
Marcio Siqueira, PhD, MBA
easyLab Technologies Ltd
Science & Technology Centre
The University of Reading
Earley Gate, Whiteknights Road
Reading, Berkshire, RG6 6BZ, UK
Tel: +44 (0)118 935 7272
Mob: +44 (0)7766 587 026
Fax: +44 (0)118 935 7271
visit us at www.easyLab.co.uk
Post a Comment